ACV Delta Classic Spezifikationen

INSTALLATION, OPERATINGAND SERVICING INSTRUCTIONSDELTA Classic Combination boilerwith atmospheric burnerACV reserves the right to modality the techni

6.1 EFFECTIVE DIMENSIONSThe units are delivered fully assembled, tested and packed on atimber base with shockproof edges and protected by heat-shrunkp

6.5 ATMOSPHERIC BURNER6 TECHNICAL SPECIFICATION6.5.1 START-UP- Flush the gas pipe thoroughly, activate the room thermostat andset the control thermost

7.1 USING THE BOILER7.1.1 GETTING TO KNOW THE CONTROL PANEL (Fig. 21)Before doing any work on the boiler, switch off the powerat the mains switch inst

7.2 BOILER ROOM• Keep vents free at all times.• Do not store inflammable products in the boiler room.• Take care not to store corrosive products near

INTERNATIONALACV international n.vKERKPLEIN, 39B-1601 RUISBROEK - belgiumTEL.: +32 2 334 82 20FAX: +32 2 378 16 49E-MAIL: international.info@acv-world

1.1 INTENDED USERS OF THESE INSTRUCTIONSThese instructions are intended for:- the specifying engineer- the installation engineer- the user- servicing

2.1 BOILER ROOM2.1.1 ACCESSThe boiler room must be large enough to allow good access to theboiler. The following minimum distances (mm) are required a

2.2.2.2 ACV circulation kitACV offers an optional pre-assembled circulation kit comprising:- a circulator.- a 3-way manual motorisable valve.- connect

Wiring diagram of ACV controller kits (fig. 7)2 INSTALLATION2.3 ELECTRICAL CONNECTION2.3.1 POWER SUPPLYThe boiler operates with a 230 V - 50 Hz single

3.1 FILLING THE HEATING AND HOTWATER CIRCUITS1. Fill the domestic hot water circuit and bring it up to pressure.IMPORTANTThe hot water tank must be pr

4.4 SERVICING THE BURNER- Check and clean the burner and ignition electrode.- Check that the safety components are working properly.4.5 EMPTYING THE B

5.1 OVERVIEW• Combination boiler (central heating and domestic hot water).• Designed for venting through a chimney.• TANK-IN-TANK indirect storage typ

5.3 DESIGN FEATURES5.3.1 OUTER BODYThe outer body containing the primary fluid is made of STW 22 steel.5.3.2 TANK-IN-TANK TYPE EXCHANGER ACCUMULATORTh